The following conditions shall not use high-speed polishing machine
  
    The operator is not trained.

    The operator did not learn safety procedures.

    High-speed polishing machine does not operate properly.

    Second, the use of high-speed polishing machine, to respond to environmental, check the following

    The operator's hands and feet away from the rotating polishing head.

    The operator shall not slam the power cord or the power cord wrapped around the polishing head.

    The operator must dress safety.

    The polishing area shall not exceed the length of the power cord.

    The operator will be allowed to dispose of the operating handle. Shutdown, the high-speed polishing machine stopped spinning before releasing the handle.

    Can not use the sticky dust, dirt polishing pad. Fouling too much polishing pad can not be cleaned, with the change in time.

    Replacement, polishing pad is installed, it must be cut off.

    Third, the high-speed polishing machine storage

    Turn off the power.

    Tilted back, the rear wheel with storage.

    Shall not be stored outdoors, and should be stored in a dry place.